LG T730BH DRIVER DOWNLOAD

YES T pin 2 voltage is change with H frequency? Do not use freon-propelled spray-on cleaners. Adjustment should be following procedure and after warming up for a minimum of 30 minutes. Trace along the copper pattern from both sides of the pattern break and locate the nearest component that is directly connected to the affected copper pattern. Bend the two remaining leads perpendicular y to the circuit board. Check QCheck 13V line.

Uploader: JoJole
Date Added: 23 October 2015
File Size: 23.62 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 81681
Price: Free* [*Free Regsitration Required]

Keep the soldering iron tip clean and well tinned. Adjustment should be following procedure and afterwarming up for a minimum of 30 minutes. NO Check Q and related components.

LG Flatron ez TBH monitor specifications

TbhklFlatron tbhkFlatron tdsh kFlatron tshFlatron tshk. Please, do not make a copy of the downloaded manual and do not offer t730gh sell it, just use personally to repair defective appliance!

Your manual failed to upload There are special components used in this color monitor which are important for safety. NO Check and replace T and Q Cut off point at the center of the display area Note: Use ly grounded-tip, low-wattage soldering iron andappropriate tip size and shape that will maintain tiptemperature within the range or F to F.

  DYNEX DX-E402 DRIVER

Do not test high voltage by “drawing an arc”. However, when the high voltage circuitry is operating properly there is no possibility of an X-radiation problem.

LG Electronics T730BH Computer Monitor User Manual

Adjustment should be following procedure and after warming up for a minimum of 30 minutes. This is implemented using a radio receiver having a tunable receiving frequency.

YESAging t730bhh andcheck for focus change. These free programs can be found on this page: YES Q collecter waveform is right? Replace CRT and verify purity.

Inspect on the circuit board copper side the solder joints of the two “original” leads. Adjustment for White Balance and Luminance.

These free programs can be found on this page: Good luck to lf repair! Test high voltage only by measuring it with an appropriate high voltage meter or other voltage measuring device DVM, FETVOM, etc equipped with a suitable high voltage probe. T Pin 6 Voltage exists? Always remove the test receiver ground lead last.

  FLEXTIGHT 848 DRIVER

LG FLATRON TBH SERVICE MANUAL Pdf Download.

Check the CRT Socket. First, hold the t370bh iron tip and solder the strand against the component lead until the solder melts. Displa Size drift 4mm: NO Check and replace function key. IC Pin22input exists and varieswith different patterns? NO Replace failed part.

What’s missing? Tell us about it.

Thoroughly clean the surfaces to be soldered. Positive or Negative There is no preview for this item! YES T pin 2 voltage is change with H frequency?

Author: admin